Dear Narasimhan,
You can make the set-up by yourself. Buy a Teflon block of 5 or 7cm dia then
cut it into the height approx. 12cm. Make it hollow with the inner dia of 2cm
and make 6 holes for screws (3mm).

Make a groove to place o-ring.

Buy a stainless steel of same 7cm dia and make holes for threading screws
matching with the holes on teflon. Buy screws and nuts.

You should have a Platinum mesh for cathode.


Refer Lehmann's paper.

With best wishes,
Sujatha


---------- Original Message -----------
From: Ini Narasimhan 
To: [email protected]
Sent: Wed, 3 Oct 2007 09:12:08 -0700 (PDT)
Subject: [mems-talk] Electrochemical setup for Porous silicon

> Dear Members,
>
> I am a Ph.D candidate from the City College of New York. I am trying
> to setup an electrochemical etching process to manufacture porous
> silicon using silicon. I would also like to know the apparatus that
> are required and their manufacturers. It would be great if anyone
> could assit me with this. Thank you.