Hi,
 You should  try low deposition rate / lower power.

-Ravi Kumar.k

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Daniel Fine
Sent: Monday, March 31, 2008 8:38 PM
To: [email protected]
Subject: [mems-talk] Pyrex ebeam evaporation

Hello,

  My name is Daniel Fine and I am a post doc at the University of Texas
at Austin.  I am trying to ebeam evaporate Pyrex (7740) and am running
into a problem where I am finding it hard to prevent bubbling and thus
spitting of the material when I try to achieve deposition rates of 5
Angstrom per second or higher.  The films are therefore covered with
non-uniform streaks of Pyrex.  I am using a CHA evaporator.  I have
tried a steady beam spot in one place and an oscillating beam spot as
well but get the same problem of large bubble formation.  I would
greatly appreciate any input concerning how I might over come this
problem.

Thanks,
  Daniel Fine