Ameya,

Try an air-brush to spray coat resist, you might need to dilute your
medium with solvent and thoroughly clean the brush after every session,
but it works OK for some applications.

Loren

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of ameya g
Sent: Wednesday, November 11, 2009 10:58 PM
To: General MEMS discussion
Subject: Re: [mems-talk] Photolithography on a rough surface

Thanks for the suggestions. I think spray coating seems to be a very
good
solution to my problem. I am from Arizona State University and I am not
sure

if I can find a spray coater at my university. If there is anyone on the
mailing
list from ASU who has a spray coater, kindly send me an email.

Thanks,
-Ameya - [email protected]