That's far too great a roughness. It could be a dirty showerhead dropping
particles on the wafer. Or perhaps your discharge power is too great and
nitride is forming in the gas instead of reacting on the surface of the
wafer.

On Tue, Feb 17, 2015 at 4:07 PM, Matthieu Nannini, Dr. <
[email protected]> wrote:

> Hi,
>
> I’m wondering how low the roughness could be on a SiN PECVD layer of 50 to
> 300nm ? anybody could share data ?
>
> Thanks
>
> -----------------------------------
> Matthieu Nannini
> McGill Nanotools Microfab
> Manager
> t: 514 398 3310
> c: 514 758 3311
> f: 514 398 8434
> http://mnm.physics.mcgill.ca/
> ------------------------------------
>
> _______________________________________________
> Hosted by the MEMS and Nanotechnology Exchange, the country's leading
> provider of MEMS and Nanotechnology design and fabrication services.
> Visit us at http://www.mems-exchange.org
>
> Want to advertise to this community?  See http://www.memsnet.org
>
> To unsubscribe:
> http://mail.mems-exchange.org/mailman/listinfo/mems-talk
>
_______________________________________________
Hosted by the MEMS and Nanotechnology Exchange, the country's leading
provider of MEMS and Nanotechnology design and fabrication services.
Visit us at http://www.mems-exchange.org

Want to advertise to this community?  See http://www.memsnet.org

To unsubscribe:
http://mail.mems-exchange.org/mailman/listinfo/mems-talk